Close

 subscribed threads only
Play  Pause

Event By Thread/Post Forum
New Post
Ericbh77
Today 03:56 PM
 Motor build
mourad@vacmotorsport s.com (1,032 views, 19 replies)
New Post
Chris@VargasTurboTech
Today 03:38 PM
 VPG Cracks 650+ whp Direct Injection Only
Clarification: The "prototype hpfp system" is, as indicated, speaking from a system point of view. The actual hpfp itself from a component level is unchanged and unopened. 100% stock. The... (138 views, 3 replies)
New Post
ChuckD05
Today 02:55 PM
 Pure stage 2 Auto 135i vs Vargas stage 2+ 335is
i wish my tranny didnt tell me to Fuk off after 4k miles at 500whp lol (741 views, 12 replies)
New Thread
AdminTeam
Today 02:53 PM
 NOOOOB: EdgardoMan
EdgardoMan, we appreciate you taking the time to join. (23 views, 0 replies)
New Post
Den*
Today 02:51 PM
 Motiv single turbo questions
an yreason of using water cooling in WG? (390 views, 7 replies)
New Post
Den*
Today 02:49 PM
 New things happening at DOC Race
what about flow distribution across 1 to 6 cyl, using this receiver/intake manifold? (2,066 views, 33 replies)
New Post
natedog7700
Today 02:42 PM
 Propulsive Dynamics ZF6HP19/21 upgraded transmission bushings information
Same here. Fingers crossed for 750+ crank HP limit. (840 views, 31 replies)
New Post
Den*
Today 01:50 PM
 Introducing JPworks BMW n54 top mount manifolds
well, i was so close to finalize tuning, but !@#$ silicone lines... just blown up:) i have stainless steel lines, it will take some time to setup it again. any recommendations on stainless steel... (63,380 views, 1,065 replies)
New Post
bigdnno98
Today 01:12 PM
 MOTIV Built N54 Shenanigans
LMAO!!! (5,225 views, 77 replies)
New Post
J. Dub
Today 01:04 PM
 Another blown engine / Questions
I just ordered the free kit. I will let you know when I get it and send it off. (6,444 views, 183 replies)
New Post
SpeedLimit?
Today 12:52 PM
 Automotive Picture of the day....
49983 (373,581 views, 3,301 replies)
New Post
johnnyblaze
Today 12:52 PM
 Finally, this is the 2018 C190 AMG GT R - New turbos, higher compression M177, 577...
That burble and exhaust note... http://www.reactiongifs.us/wp-content/uploads/2014/03/stop_penis_erect_arc her-gap.jpg (138 views, 24 replies)
New Post
Chris@VargasTurboTech
Today 12:49 PM
 VTT Silicone charge pipe nears completion
See this angle to help too: 49982 (20,104 views, 343 replies)
New Post
AWSAWS
Today 12:19 PM
 Octane, ethanol
It's incredible that due to the latent heat of evaporation of ethanol that E85 is considered superior to many race fuels like C16 etc. As long as E85 is actually E85 and not E70 etc. Plus the cost... (1,004 views, 19 replies)
New Thread
AdminTeam
Today 12:07 PM
 Let's point and laugh at LyleLance2
Welcome LyleLance2, take a look around, I think you will like what you see. (62 views, 0 replies)
New Post
Newguy123
Today 11:26 AM
 New Pure Turbos cast N54 upgrade option
i got to ride in the PURE cast test car over the weekend, even on a 23-24psi peak map the car pulls like fawking freight train. cant wait to see what it puts down on some big boosT...if it stays on... (12,053 views, 170 replies)
New Post
Chris@CKI
Today 11:24 AM
 Meth system capabilities
Your fine with the 6x CM3's but i wouldnt go cm5 in the CP. CM1 or cm2 will be just fine. All aquatek pumps like cooling mist can flow roughly 1500cc/min. The above set up i suggest is about... (220 views, 2 replies)
New Post
TwistedTuning
Today 10:41 AM
 dwell table changes anyone?
yes,you cant really overcharge the coils persay. if you were on stock or delphi coils, the changes wouldnt have made a difference since the dwell values are already good for them. So your results... (334 views, 7 replies)
New Post
Sered
Today 09:56 AM
 Single Turbo Exhaust Set-ups
Thanks man :) Going to try driving it on a 600mi trip this weekend! (1,326 views, 28 replies)
New Thread
AdminTeam
Today 09:54 AM
 Estella06Q is now here!
Estella06Q, we appreciate you taking the time to join. (72 views, 0 replies)