12-29-2013, 08:06 PM #1
2DC3 and 2E8D Codes: N54 Question
Scanned for codes and saw these two in the list with a P in front of them (with COBB).
Only thing I did recently was swap out my OEM LPFP for a new one that I did without disconnecting the battery a week ago. After the fuel pump install I scanned for codes and there were none, and also went WOT a few times with no codes post install.
Control clamp 15, and Intelligent battery sensor signal transmission are the code descriptions, respectively. What I did today is cleared the codes, unplugged the battery, then reset ECU in COBB's menu and no codes have come back. I haven't driven it since.
Any thoughts? Thanks guys.
12-30-2013, 01:02 AM #2
01-03-2014, 07:48 PM #3
01-03-2014, 08:19 PM #4Supporting Vendor
- Join Date
- Jun 2012
- Austin, TX
- Rep Points
- 91 Post(s)
- Rep Power
Sounds like something wonky with the battery module. I would do as MAC says and see if they come back. If they don't, I wouldn't worry about it. Could have simply been from messing with the plugs around the pump. If they do come back, you may need some new parts for the battery module/sensor.
02-01-2014, 12:41 AM #5