02-16-2013, 06:25 PM #1
ICS/RK tuning Crack 800whp on the stock DME.... Hi 5
Here are some updates that FutureRoadRacer' asked me to upload.
703.8 WHP (check out that tire spin)
Attempted Solution to tire spin. Still no traction on the dyno as can been seen in the dyno sheets
800 whp at 27psi.
if only the car wouldnt destroy the tires down low the torque would show EVEN higher.
02-16-2013, 06:32 PM #2
Stock DME and 800 wheel, that's serious business.
These two certainly deserve a good amount of credit. Would love to see dynojet figures as not sure on the correction but regardless, respect.
Now to get George to figure out Paypal and we can start promoting this stuff.
02-16-2013, 06:41 PM #3
02-16-2013, 06:46 PM #4
02-16-2013, 06:57 PM #5
02-18-2013, 01:41 AM #6Supporting Vendor
- Join Date
- Feb 2011
- Rep Points
- 4 Post(s)
- Rep Power
638whp put this car at 144mph and it had to be shifted into fifth
now the new rear diff will allow the car to finish in 4th
hopfuly netting a 155mph trap speed.
also that was at 27psi. the goal of the car is 30-32psi.
02-18-2013, 08:10 PM #7
02-20-2013, 04:40 PM #8
02-20-2013, 05:47 PM #9