09-17-2012, 01:11 PM #1
Cobb AP logging issue with beta firmware
I am noticing that what the live monitor says and what is actually logged show two different things.
E.g. Cylinder 1 will show 0 degrees of advance however the log shows otherwise.
Is this a known issue which can be fixed by switching to non-beta firmware?
09-17-2012, 01:17 PM #2
Are you talking about watching it during the actual pull? Or are you you talking about looking at the min/max values displayed after the pull? If you're talking about the min/max that resets when you stop logging, at least it has in my experience.
MOTIV750, MOTIV P-1000 PI, MOTIV/FUEL-IT! low pressure fuel system, AEM EMS/COBB AP, Aquamist HFS-3, ETS FMIC, SPEC stage 3+ clutch/SS flywheel, BC Racing coilovers and VMR wheels wrapped in Hankook RS3s.
09-17-2012, 01:18 PM #3
I think the refresh rate on the live monitor is not as fast as when its logging to a .csv file, but I could be wrong. I've noticed the same thing out of my P3 boost gauge as well (referring to the refresh rate)From all the things I've lost,
I miss my mind the most!
09-17-2012, 01:21 PM #4
09-17-2012, 01:22 PM #5