Close

Results 1 to 13 of 13
  1. #1
    Join Date
    Dec 2009
    Posts
    301
    Rep Points
    187.0
    Mentioned
    0 Post(s)
    Rep Power
    2


    Yes Reputation No

    wtf wrong with my car???

    so i was trying to launch my car... out in 2nd gear..... floor it - - accidently hit that stupid $#@! bottom.... it went to first gear..... after that ... car didnt go for few sec.. probably turbo llag.... after that
    my car felt like lost power....... no sick engine light.....i pulled over and over my hood .. my engine was shaking bad. then i restart my car and every thing was fine....

    anyone have this happen???


    MOds jb3 FMCI DCI BOV
    Click here to enlarge

  2. #2
    Join Date
    Nov 2009
    Location
    Simi Valley, CA
    Posts
    8,220
    Rep Points
    9,376.5
    Mentioned
    656 Post(s)
    Rep Power
    94


    Yes Reputation No
    Sounds like a misfire code but those leave an SES light. Do a BT scan and see.

  3. #3
    Join Date
    Dec 2009
    Posts
    301
    Rep Points
    187.0
    Mentioned
    0 Post(s)
    Rep Power
    2



    Yes Reputation No
    will there stil be code. my car run fine now????

    damn i was racing a camro ss too - -
    Click here to enlarge

  4. #4
    Join Date
    Nov 2009
    Location
    Simi Valley, CA
    Posts
    8,220
    Rep Points
    9,376.5
    Mentioned
    656 Post(s)
    Rep Power
    94


    Yes Reputation No
    Yes

  5. #5
    Join Date
    Dec 2009
    Posts
    301
    Rep Points
    187.0
    Mentioned
    0 Post(s)
    Rep Power
    2



    Yes Reputation No
    do you think is my HPFP
    Click here to enlarge

  6. #6
    Join Date
    Nov 2009
    Location
    Simi Valley, CA
    Posts
    8,220
    Rep Points
    9,376.5
    Mentioned
    656 Post(s)
    Rep Power
    94


    Yes Reputation No
    I don't diagnose problems without a code read out. It's a waste of time.

  7. #7
    Join Date
    Mar 2010
    Posts
    642
    Rep Points
    97.0
    Mentioned
    51 Post(s)
    Rep Power
    0


    Yes Reputation No
    If you're car threw an SES under load and idled roughly until you shut it off and restarted it, then yes, you did trigger a misfire code. Probably a cyl 6 code and perhaps also a random misfire code. But yes, a code read will confirm this.

    Shiv

  8. #8
    Join Date
    Feb 2010
    Location
    Miami Beach
    Posts
    1,087
    Rep Points
    513.4
    Mentioned
    10 Post(s)
    Rep Power
    6


    Yes Reputation No
    Your car hates and was about to blow up, but lucky it had a change of heart for you and didn't......you lucky bastard! Click here to enlarge
    Click here to enlarge

  9. #9
    Join Date
    Dec 2009
    Posts
    301
    Rep Points
    187.0
    Mentioned
    0 Post(s)
    Rep Power
    2



    Yes Reputation No
    Click here to enlarge Originally Posted by lamia2super Click here to enlarge
    Your car hates and was about to blow up, but lucky it had a change of heart for you and didn't......you lucky bastard! Click here to enlarge
    damn i wish it blow up.... so i can get a e46 m3 with HPF lol
    Click here to enlarge

  10. #10
    Join Date
    Feb 2010
    Location
    Miami Beach
    Posts
    1,087
    Rep Points
    513.4
    Mentioned
    10 Post(s)
    Rep Power
    6


    Yes Reputation No
    Click here to enlarge Originally Posted by greatest335i Click here to enlarge
    damn i wish it blow up.... so i can get a e46 m3 with HPF lol
    lol
    Click here to enlarge

  11. #11
    Join Date
    Dec 2009
    Posts
    301
    Rep Points
    187.0
    Mentioned
    0 Post(s)
    Rep Power
    2



    Yes Reputation No
    here the codes
    2F6C:
    2F6C Exhaust fumeflap, input signal
    Error will not cause a warning light
    Error is not currently present
    Test conditions have been completed
    Timeout

    Freeze Frame Information
    Event 1
    Odometer 49648kms 30849miles
    Speed 0 km/h
    time since start end 0 s
    pedal sensor 1 0 %
    voltage Kl. 87 11.88 V
    Event 2
    Odometer 49664kms 30859miles
    Speed 0 km/h
    time since start end 0 s
    pedal sensor 1 0 %
    voltage Kl. 87 11.88 V
    Event 3
    Odometer 52208kms 32440miles
    Speed 0 km/h
    time since start end 0 s
    pedal sensor 1 0 %
    voltage Kl. 87 11.98 V


    2AAF:
    2AAF Fuel pump, plausibility
    Error will not cause a warning light
    Error is not currently present
    Test conditions have been completed
    Short circuit or signal interruption

    Freeze Frame Information
    Event 1
    Odometer 49648kms 30849miles
    fuel pressure before mass control valve 4,754.82 hPa
    Engine speed 1,440.00 rpm
    voltage Kl. 87 13.71 V
    injected mass of fuel 4 l/h
    Event 2
    Odometer 49664kms 30859miles
    fuel pressure before mass control valve 4,924.64 hPa
    Engine speed 1,408.00 rpm
    voltage Kl. 87 13.81 V
    injected mass of fuel 7 l/h
    Event 3
    Odometer 52208kms 32440miles
    fuel pressure before mass control valve 4,245.38 hPa
    Engine speed 1,344.00 rpm
    voltage Kl. 87 13.71 V
    injected mass of fuel 8 l/h


    2FBF:
    2FBF Fuel pressure at injection release
    Error will not cause a warning light
    Error is not currently present
    Test conditions have been completed
    Short circuit or signal interruption

    Freeze Frame Information
    Event 1
    Odometer 50048kms 31098miles
    rail pressure 5,434.07 hPa
    PWM-Signal of mass control valve 47.66 %
    voltage Kl. 87 10.97 V
    fuel pressure before mass control valve 5,052.00 hPa
    Event 2
    Odometer 50080kms 31118miles
    rail pressure 5,434.07 hPa
    PWM-Signal of mass control valve 57.81 %
    voltage Kl. 87 10.97 V
    fuel pressure before mass control valve 5,009.54 hPa
    Event 3
    Odometer 52072kms 32356miles
    rail pressure 6,792.59 hPa
    PWM-Signal of mass control valve 58.59 %
    voltage Kl. 87 10.87 V
    fuel pressure before mass control valve 5,009.54 hPa


    30FF:
    30FF Exhaust fume turbo charger, low pressure side
    Error will not cause a warning light
    Error is not currently present
    Test conditions have been completed

    Freeze Frame Information
    Event 1
    Odometer 51152kms 31784miles
    ambient pressure 997.66 hPa
    ambient temperature 22.5 C
    pressure in front of throttle valve 102 kPa
    speed 2,304.00 rpm


    29DC:
    29DC Cylinder injection switch-off
    Error will cause a warning light
    Error is not currently present
    Test conditions have not been completed
    Short circuit or signal interruption

    Freeze Frame Information
    Event 1
    Odometer 52064kms 32351miles
    Engine temperature 98.25 C
    air mass calculated 841.01 mg/stk
    Engine speed 2,688.00 rpm
    fuel tank filling level 17 l
    Click here to enlarge

  12. #12
    Join Date
    Nov 2009
    Location
    Simi Valley, CA
    Posts
    8,220
    Rep Points
    9,376.5
    Mentioned
    656 Post(s)
    Rep Power
    94


    Yes Reputation No
    Looks like an impending fuel pump problem to me.

  13. #13
    Join Date
    Dec 2009
    Posts
    301
    Rep Points
    187.0
    Mentioned
    0 Post(s)
    Rep Power
    2



    Yes Reputation No
    god damn fuel pump = = guess have to take off mods and DEALERRRRRRRRRRRRRRRRRRRRRRRRRRRR TIME !
    Click here to enlarge

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may post replies
  • You may not post attachments
  • You may not edit your posts
  •